v2 Assembly Instructions

To setup your HMG - Spacebucket v2:

  1. Attach the 2 fan adapters and fans to the bucket
  2. Plug the fan power connector into the 12v power supply connector.
  3. Fit the top bucket into the base bucket.
  4. Place a UFO LED grow light on top of the top bucket.
  5. Plug the 12v power supply and UFO LED grow light power line into the power strip.

1. Attach the 2 fan adapters and fans to the bucket

Use the 4 provided screws and nuts to attach the 2 fan adapters to the buckets. Each fan adapter requires 2 screws and 2 nuts to secure it to the bucket.

2. Plug the fan power connector into the 12v power supply connector.

3. Fit the top bucket into the base bucket.

Make sure that the top bucket is snuggly fit into the base bucket. The snug fit should prevent any air from leaking out of the sides of connecting the two buckets. There are two bucket extensions that can be used to extend the height of the system.

4. Place a UFO LED grow light on top of the top bucket.

5. Plug the 12v power supply and UFO LED grow light power line into the power strip.

Note: You can mount the power strip to the side of the base bucket with duck tape. As a note of caution, please remember to plug the power strip into a GFCI socket. Doing so will prevent serious shock from the wall power supply if something were to go wrong.